Everything below concerns CJC-1295. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-05-12. Numbers and descriptions here follow the published literature rather than marketing material.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Assessed by visual inspection under ordinary light |
| Primary analytical method | Reversed-phase liquid chromatography | Purity estimated from peak area at 214 nm |
| Confirmatory method | Mass spectrometry | Observed mass compared with calculated value |
| Powder storage temperature | Minus 20 degrees Celsius | Minus 80 for extended archival periods |
| Solution stability | Hours to days at 2 to 8 degrees Celsius | Influenced by pH, buffer, and concentration |
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
Four amino acid substitutions separate the modified backbone from the parent GRF(1-29) sequence. These changes reduce recognition by dipeptidyl peptidase IV and related proteases, extending the interval before degradation. Development work in this area sought longer-acting GHRH analogs for endocrine investigation. Published descriptions treat the substitution set as a defining property of the core sequence, while the albumin-binding linker is described separately as an optional addition to that same backbone.
CJC-1295 is a synthetic peptide analog of growth hormone-releasing hormone, constructed on the 29-amino-acid fragment designated GRF(1-29). The name began as an internal development code during the 1990s and later spread through research supply catalogs and discussion forums. The molecule does not occur in nature; its sequence is engineered rather than isolated from tissue. Two related compounds are sold under this single label, and they differ by one appended chemical group that strongly influences how long the peptide remains in circulation.
The dividing feature between the two forms is a maleimide-based drug affinity complex, abbreviated DAC. In the DAC-bearing version, a linker attaches the peptide to serum albumin after administration, and that association slows removal from plasma. The version lacking DAC appears in catalogs as MOD GRF(1-29) or tetrasubstituted GRF(1-29). Because informal writing treats both as one item, comparisons drawn from such sources routinely blend measurements taken from two molecules with substantially different behavior.
Blastula-stage cells can behave as pluripotent stem cells in many species. Pluripotent stem cells are the starting point to produce organ specific cells that can potentially aid in repair and prevention of injury and degeneration. Combining the expression of transcription factors and locational positioning of the blastula cells can lead to the development of induced functional organs and tissues. Pluripotent Xenopus cells, when used in an in vivo strategy, were able to form into functional retinas. By transplanting them to the eye field on the neural plate, and by inducing several mis-expressions of transcription factors, the cells were committed to the retinal lineage and could guide vision based behavior in the Xenopus. Polarity in embryogenesis Diploblasty Triploblasty
In 2017, PTC acquired Emflaza (deflazacort) from Marathon Pharmaceuticals. PTC also owns Translarna, (Ataluren) marketed for nonsense mutation Duchenne muscular dystrophy. Together, the two products generated revenues of 174 million dollars and 260 million dollars in 2017 and 2018 respectively. PTC has the commercialization rights for WAYLIVRA (volanesorsen) in Latin America. In 2018, PTC acquired Agilis Biotherapeutics and a gene therapy candidate, GT-AADC, with its compelling clinical data in treating aromatic L-amino acid decarboxylase (AADC) deficiency. AADC deficiency is a rare CNS disorder arising from reductions in the enzyme AADC that result from mutations in the dopa decarboxylase (DDC) gene. As of 2024, the AAV based treatment for AADC deficiency has been approved by the FDA and commercialized in the United States as Kebilidi. It is the first FDA-approved gene therapy treatment for AADC deficiency. This same product was granted EMA approval for use in the European Union under the name Upstaza.
The global blood testing market was valued at approximately USD 96.62 billion in 2024 and is projected to reach USD 160.50 billion by 2030, growing at a compound annual growth rate (CAGR) of 8.83%. The DTC segment represents a rapidly growing portion of this market, fueled by increasing consumer health awareness and technological innovations in sample collection and analysis. North America dominates the market with the largest revenue share (approximately 44.83% in 2024), driven by well-established healthcare infrastructure, favorable regulatory environments in many states, and high consumer acceptance of self-directed healthcare services.
Sources: en.wikipedia.org
The MEROPS protease database includes the following ten families of asparagine peptide lyases, which are included in 6 different clans of proteases. Proteolytic enzymes are classified into families based on sequence similarity. Each family includes proteolytic enzymes with homologous sequences and common catalytic type. Clans are groups of proteolytic enzymes families with related structures, where catalytic type is not conserved. *Not yet included in IUBMB recommendations. The ten different families of asparagine peptide lyases are distributed in three different types: Viral coat proteins Autotransporter proteins Intein-containing proteins There are five families of viral coat proteins (N1, N2, N8, N7 and N5), two families of autotransporter proteins (N6 and N4) and three families of intein-containing proteins (N9, N10 and N11).
An organic compound is a chemical whose molecules contain carbon. Carbon is abundant in the Sun, stars, comets, and in the atmospheres of most planets of the Solar System. Organic compounds are relatively common in space, formed by "factories of complex molecular synthesis" which occur in molecular clouds and circumstellar envelopes, and chemically evolve after reactions are initiated mostly by ionizing radiation. Purine and pyrimidine nucleobases including guanine, adenine, cytosine, uracil, and thymine, as well as sugars, have been found in meteorites. These could have provided the materials for DNA and RNA to form on the early Earth. The amino acid glycine was found in material ejected from comet Wild 2; it had earlier been detected in meteorites. Comets are encrusted with dark material, thought to be a tar-like organic substance formed from simple carbon compounds under ionizing radiation. A rain of material from comets could have brought such complex organic molecules to Earth. During the Late Heavy Bombardment, meteorites may have delivered up to five million tons of organic prebiotic elements to Earth per year. Currently 40,000 tons of cosmic dust falls to Earth each year.
Other 1,2- and 1,3-dithiols give related 1,3-dithiolanes (five-membered) and 1,3-dithianes (six-membered rings). Diols such as ethylene glycol undergo analogous reactions to give 1,3-dioxolanes. One distinguishing feature of the dithiolanes and dithianes derived from aldehydes is that the methyne group can be deprotonated and the resulting carbanion alkylated. 1,2-Ethanedithiol has been used as a scavenger in peptide cleavage synthesis. Like 1,3-propanedithiol, 1,2-ethanedithiol readily forms metal thiolate complexes. Illustrative is the synthesis of the derivative diiron ethanedithiolate hexacarbonyl upon reaction with triiron dodecacarbonyl: Fe3(CO)12 + C2H4(SH)2 → Fe2(S2C2H4)(CO)6 + H2 + Fe(CO)5 + CO Ethane-1,1-dithiol
Polycondensation involves the formation of polymers through condensation reactions between different species, creating condensation polymers. With automated synthesis, General electric manufactured an approach for melt-polymerizations of BPA and diphenyl carbonate (DPC), using sodium hydroxide (NaOH) as the catalyst. Once the results were analyzed, it was shown that, by using an automated method of polymerization, the effect of varying the catalyst amount became more distinct and improved the reproducibility for the reaction. Furthermore, it demonstrated an increase within the homogeneity of the polymers in the microreactors.
Sources: en.wikipedia.org
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.
Dry powder is markedly more stable than solution and is usually held frozen and desiccated. Room temperature exposure over days degrades it more slowly than most people assume, but long-term integrity favors freezer storage. Light protection is recommended regardless of temperature.
Methods, columns, gradients, and detection wavelengths are not standardized across laboratories. Some figures describe only the main peak area at one wavelength and ignore water, salts, or counter-ions. Without stated conditions, comparing reported percentages across sources is unreliable.
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.